QS-CH1 MOTION SYSTEM
Dhs. 59,852
Please select all options.
QS-CH1 FULL SET
2 x QS-220-PL motion set:
4x QS-L1 – linear actuator with stabilization plate
2x QS-SB2 – power cabinet (control module)
1x QS-SBML-2 – motion lock cable (up-link/down-link) – 2 meters long
1x Ethernet RJ-45 cable – 2 meters long
1x Power cable
1x QS-MC6 controller set:
1x M10 – USB controller
1x QS-SBML-1 – motion lock with additional cable
1x QS-MBT-1 – M-BUS terminator (RJ45 plug with resistor)
1x USB cable (mini)
1x Ethernet RJ-45 cable – 3 meters long
Dedicated, stiff rig with attaching points and mounting brackets:
2x mounting bracket: power cabinet
4x mounting bracket: actuator
1x mounting bracket: steering wheel with adjustment
1x mounting bracket: pedals
1x mounting bracket: racing seat with adjustment
QS-CH1 BASE
1x motion floor with mounting brackets:
2x mounting bracket: power cabinet
4x mounting bracket: actuator
1x mounting bracket: steering wheel with adjustment
1x mounting bracket: pedals
1x mounting bracket: racing seat with adjustment
QS-CH1 GENERAL SPECIFICATION
Architecture: 3DOF
Actuator stroke: 100 mm | 3.93 in
Vibration frequency range: 0-100 Hz
Maximum control frequency: 1000 Hz
Maximum velocity:
◦ Heavy Duty Mode (115/230V): 300 mm/s
Maximum acceleration:
◦ Heavy Duty Mode (115/230V): 0.4G*
*value of acceleration is limited for safety reasons
QS-CH1 SYSTEM PERFORMANCE
Heave: – 50 mm, 50 mm
Roll: -7.9°, 7.9°
Pitch: -5.1°, 5.1°
QS-CH1 DIMENSIONS
Total length: 1426 mm | 56 in
Total width: 856 mm | 33.7 in
Total height: 763 mm | 30 in
QS-CH1 PAYLOAD
Gross moving load: 300kg
POWER REQUIREMENTS
Power supply requirements: 115/230 VAC Single Phase
Average power consumption in 3DOF configuration:
◦ Q-Mode: 260W (230V)
◦ Performance Mode: 280W (230V), 270W (115V)
◦ Heavy Duty Mode: 436W (230V), 462W (115V)
Peak current for breaker specification in 3DOF configuration:
◦ Q-Mode: 5.17A (230V)
◦ Performance Mode: 4.55A (230V), 7.35A (115V)
◦ Heavy Duty Mode: 5.88A (230V), 9.89A (115V)
Connection: USB
Lead time: Pre-order